 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| Microwave Motion Sensor KMY 24 Description The KMY 24 is a microwave rader motion sensor based on the Doppler effect. It transmits a low energy microwave radiation at 2.45 GHz which is reflected by objects. If the object is moving relative to the sensor, a Doppler shift occurs. The shifted wave is mixed with the original wave in two mixers, resulting in two output voltage signals. The phase shift between these two signals is negative or positive depending on whether the target is approaching or receding from the detector. Features * * * * * * * * High sensitivity Dual Mixers enabling direction detecting High reliability Low power consumption Low harmonic emission Small size Light weight Low cost Marking KMY 24 Ordering Code Operating Frequency Q62702-R323 2.45 GHz License No. BZT G127520H Typ KMY 24 Pin Configuration 1 2 3 4 - VS (GND) VD1 (output voltage D1) VD2 (output voltage D2) + VS SIEMENS KMY 24 Notes: 1234 1. Solder pads must not be perforated, as this will damage, EHA07260 and may destroy the multilayer PC Board. 2. Regulations on the use of High frequency devices. The use of high frequency devices is regulated in most countries and certain frequencies can be subject to restrictions. The use of the KMY 24 should be clarified with the respective authorities in each country to ensure compliance with the prevalent legislation. Data Sheet 1 1999-04-01 KMY 24 Absolute Maximum Ratings Parameter Operating temperature range Storage temperature range Supply voltage Electrical Characteristics at TA = 25 C Parameter Supply voltage Operating frequency Operating current Detecting range1) Amplitude of signal 1 Quotient of amplitude of 1 and 2 Phase difference Equivalent isotropic radiated power at fo Symbol min. Limit Values typ. 12 2.45 23 5...8 1) Symbol Top Tstg VS Limit Values - 20 ... + 60 - 30 ... + 80 15.6 Unit C C V Unit V GHz mA m mV Degrees dBm max. 15.6 2.48 - - - - - VS fo Iop rop VD1 VD1/VD2 2 - 1 10.8 2.40 - - - - - - 2 8 40 ... 120 - EIRP 1) The amplitude of the signal depends on the object size and its distance from the detector. Measurements taken with 5 cm high, cylindrical metallic objects, moving in circles at a distance of 1 m for example, give signal amplitudes of typically VD1 = 40 mV. Data Sheet 2 1999-04-01 KMY 24 Output Signal The phase difference between VD2 and VD1 is positive, if the target is receding from the detector. ( 1 - 2 ) 0 EHA07261 VD1 VD2 Receding Ch1 10 mV Ch2 10 mV M 100 ms The phase difference between VD2 and VD1 is negative, if the target is approaching the detector. ( 1 - 2 ) 0 EHA07262 Approaching VD1 VD2 Ch1 10 mV Ch2 10 mV M 100 ms Data Sheet 3 1999-04-01 KMY 24 Typical Radiation Pattern The diagram shows the typical radiation pattern in the x-z- and y-z-planes. The z-direction is perpendicular to the patch antenna, x shows the longer and y the shorter side of the rectangular antenna. 0 0 dB -10 dB 60 -20 dB 90 30 EHA07263 Package Outline Special Package 38 5.5 Marking 3 3 0.8 2.5 15.2 o3.2 26 5 EHA07466 Sorts of Packing Package outlines for tubes, trays etc. are contained in our Data Book "Package Information". Data Sheet 4 19.9 Dimensions in mm 1999-04-01 |
Price & Availability of Q62702-R323
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |